Emitted Voltage Spikes Test

MIL-STD-1275 D/E/F

MIL-STD-1275 28V DC Input Power Specifications for Devices for Use in Military Vehicles The D/E/F military standard includes a series of test procedures to determine the power supply requirements of electronic devices used in military systems and to protect against sudden voltage emissions. These test procedures include the sudden voltage release test.
Emitted Voltage Spikes Test is a test performed to measure the resistance of the electrical systems inside the vehicle to sudden voltage fluctuations that occur in the system during engine operation or due to some other reasons. In the Sudden Emitted Voltage Spikes Test, the power output from the vehicle battery or alternator is suddenly increased and how electronic devices react to this sudden power increase is measured.

The voltage waveform used in the Instantaneous Voltage Release Test is defined in the MIL-STD-1275 D/E/F standard and is generally applied with voltage levels of 12V DC or 24V DC. During the Sudden Voltage Release Test, the operating status of electronic devices is monitored and whether there is any damage or deterioration in their operation is observed.

The Emitted Voltage Spikes Test, included in the MIL-STD-1275 D/E/F standard, is an important test to ensure that the electronic devices in the military vehicle are protected against sudden voltage increases. With the SEmitted Voltage Spikes Test, it is ensured that the electronic devices in the vehicle remain intact and operate correctly.

Within the scope of our STEST facility located in Ankara, which is an organization accredited by TURKAK, we comply with the TS EN ISO/IEC 17025 General Requirements for the Competency of Testing and Calibration Laboratories Standard and comply with the MIL-STD-1275 28 VOLT DC INPUT POWER SPECIFICATIONS FOR DEVICES FOR USE IN MILITARY VEHICLES standard We perform Emitted Voltage Spikes Test on D/E/F versions.
In order to increase the quality and reliability of your products, you can contact us for your Environmental, EMI/EMC and ATP Testing needs.

EMI/EMC Test Chambers Features



  Test Room 1 Test Room 2 Measurement unit
Width 6850 13000 mm
Size 5900 10000 mm
Height 3800 9000 mm
Door Dimension 1000x2000 4200x4750 mm
Turntable Diameter - 6 m
Turntable Load Carrying Capacity - 70 ton
Reflection Semi Anti-Reflective Semi Anti-Reflective  


  • MIL-STD-1275D
  • MIL-STD-1275E
  • MIL-STD-1275F



+90 (312) 905 06 90